Garmin GDU-375 Software Revision Updates?

[Steve Y]

It DID fix the problem of direct transfer of a single frequency. I just updated my GDU-375 to V8.80 and it works!

David Morris
Carbon Cub #275

Three Cheers!
Update: Installed 8.80 and confirming single Frequency transfer Good along with go-to all frequency transfer.

[txcub]

Well it fixed that issue but now the wind indication in the Dynon D-180 is gone??? It also changed the Garmin display to Kts.... Unsure why it affected the D-180 but trying to figure out how to get that back.

Jon

Yes, it does transfer all frequencies when entering a direct to airport. I tested this as well as single frequency transfer!

David Morris
Carbon Cub #275

[Steve Y]

Well it fixed that issue but now the wind indication in the Dynon D-180 is gone??? It also changed the Garmin display to Kts.... Unsure why it affected the D-180 but trying to figure out how to get that back.

Jon

Using V8.80

Just flew mine. Wind working fine. Confirm it is ON (Y) on Dynon. [Push any lower soft key. Menu under EFIS-More-setup-Clutter-More-More-More-Wind Y. Pushing wind soft key toggles between Y and N (yes/no) ]

Update 8/14/14: My speed is MPH on Garmin and did not change. The Dynon Fuel used page is normal with gallons at waypoint, time etc.

Call if questions- 760-200-0448
Steve

[txcub]

Found the solution to changing back to "MPH" in the GDU-375 display in the installation manual page 4-1. Entering the "Configuration Mode" during startup.....holding down the Softkey #1. Fixed

Jon

Using V8.80

Just flew mine. Wind working fine. Confirm it is ON (Y) on Dynon. [Push any lower soft key. Menu under EFIS-More-setup-Clutter-More-More-More-Wind Y. Pushing wind soft key toggles between Y and N (yes/no) ]

Update 8/14/14: My speed is MPH on Garmin and did not change. The Dynon Fuel used page is normal with gallons at waypoint, time etc.

Call if questions- 760-200-0448
Steve

[Steve Y]

Anyone install V9.0 on the GDU-375 yet and have any input ?

[txcub]

Anyone install V9.0 on the GDU-375 yet and have any input ?

After the last update with snafu's, think I will wait till you try it first!!
Jon

[Steve Y]

After the last update with snafu's, think I will wait till you try it first!!
Jon

Ok- Installed V9.0: Radio frequency transfers seem normal, MPH stayed MPH not knots,
All seems normal. Will Test fly it as soon as weather clears, and go through all the functions in the air like
wind direction/velocity, flight plan times, etc. But for now it all seems fine.

I still get this though when I enter my home airport TAXI CHART page....

[Charles]

I still get this though when I enter my home airport TAXI CHART page....

This is retaliation from Garmin for our complaining about previous updates. Sort of tit for tat...

[Steve Y]

Test fly V9.0 for 3 hrs. Tested everything I could think of. Radio freq., flight plan, fuel, wind, etc.
Could find nothing changed or not working.

[davidmorris]

Test fly V9.0 for 3 hrs. Tested everything I could think of. Radio freq., flight plan, fuel, wind, etc.
Could find nothing changed or not working.

Thanks Steve! I will take the lead on the next update!